AMPLIFIER SETUP
If the surround back speakers are not used in the main zone, their surround
back amplifier channels could be assigned for Main back, Main Front (Bi-
Amp) and Zone 2 use.
The Surround Back amplifier is configurable through the following settings
Main Back:
Assign as surround back speakers.
Main Front (Bi-Amp):
Provide a bi-amp mode for the Main Front
speakers (Left and Right) speakers thus reproducing the Front Left and
Front Right amplifier channel outputs.
Zone 2:
Assign the surround back amplifier channels to supply Zone 2
speaker level outputs from the surround back speaker terminals. Refer
also to the item about “ZONE 2 AT AUDIO PRE-OUT SURROUND BACK” in
the “ZONE CONTROLS” segment of the “OPERATION - USING THE T 758 -
MAIN MENU” section.
TRIGGER SETUP
The T 758 features a config12V TRIGGER OUT that can be used to
activate a component or system it is fed into. It is used to turn on/off other
compliant devices.
The T 758’s +12V TRIGGER OUT is dependent on which mode it is associated
with. There are three choices where the +12V TRIGGER OUT can be assigned
and these are - Main, Zone 2 and Source Setup.
Main:
+12V DC is available at +12V TRIGGER OUT when the T 758 is at
powered state.
Zone 2:
When the Zone 2 is at powered state, +12V DC is available at
+12V TRIGGER OUT.
Source Setup:
If Trigger Output is linked to “Source Setup”, +12V DC
is available at +12V TRIGGER OUT whenever the particularly assigned
Source is selected.
DELAY
The availability of +12V DC at Trigger Out can be regulated. If it is desired
that +12V DC is available without delay the moment Trigger Out is linked
to its assigned setting, set Delay to 0s. Otherwise, one can select through a
delay time of 1s to 15s.
LISTENING MODE SETUP
The T 758 has various listening mode options and is mostly configurable.
These are provided to reproduce a variety of sound effects depending
upon the content of the source to be played. Use a combination of [
A/S
],
[
D/F
] or [ENTER] and keys to configure the following settings.
LISTENING MODES
The audio format as detected by the selected Source can be automatically
configured and processed through the following options:
DOLBY
Dolby Digital is the multi-channel digital signal format developed in the
Dolby laboratories. Discs bearing the Dolby Digital (double-D symbol) logo
were recorded with up to 5.1 channels of digital signals, reproducing a
much better sound quality, with dynamic and spatial sound sensations that
are much better than in the previous Dolby Surround.
A Dolby Digital audio input can be configured relative to its format as
follows
Stereo:
If the detected audio is of Dolby stereo format, you can default
it to one of the following settings - Pro Logic, PLIIx Movie, PLIIx Music or
None.
Surround:
If the detected audio is of Dolby Surround format, you can
default it to one of the following settings - Surround EX, PLIIx Movie,
PLIIx Music, Stereo Downmix or None.
None:
If “None” is selected, the Dolby Digital signal will be defaulted
to the “Stereo” or “Surround” settings set forth at the “PCM” option. See
discussion below about “PCM”.
OPERATION
USING THE T 758 – SETUP MENU
26
ENGLISH
POR
TUGUÊS
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ
