6 VACUUM FLUORESCENT DISPLAY (VFD)
•
Displays visual information about the current settings like the active
Source, volume level, listening mode, audio format, applicable RDS/
DAB as well as iPod-related display information and other related
indicators.
•
Refer also to the item about DISPLAY SETUP under the USING THE
T 758 - SETUP MENU segment of the OPERATION section.
7 REMOTE SENSOR
•
Point the AVR 4 remote control at the remote sensor and press the
buttons.
•
Do not expose the remote sensor of the T 758 to a strong light
source such as direct sunlight or illumination. If you do so, you may
not be able to operate the T 758 with the remote control.
Distance:
About 23ft (7m) from the front of the remote sensor.
Angle:
About 30° in each direction of the front of the remote sensor.
8
3
SOURCE
4
•
Toggle through the input selections - Source 1, Source 2, Source 3,
Source 4, iPod, Source 7, Front Input, Media Player and Tuner (AM/
FM/DAB as applicable). More Sources can be directly recalled upon
enabling them at the Setup Menu.
•
Refer also to the item about SOURCE SETUP under the USING THE
T 758 - SETUP MENU segment of the OPERATION section.
9 VOLUME
•
The VOLUME control adjusts the overall loudness of the signal being
fed to the loudspeakers or headphones.
•
Turn clockwise to increase the volume level; counter clockwise to
lower it.
10 PHONES
•
Accepts stereo headphone using a standard 1/4-inch stereo phone
plug (use a suitable adaptor for headphones equipped with a
smaller plug).
•
Plugging in headphones automatically mutes output from the
speakers.
•
For headphone listening, the Front speakers must be set to “Large” at
the “Speaker Configuration” of the Speaker Setup item at the Setup
Menu; otherwise headphone bass response will be restricted.
•
Plugging in headphones will automatically switch the T 758 to
Stereo, Stereo Downmix or Analog Bypass modes.
11 FRONT INPUT PORTS
•
Use these convenience jacks for occasional sources such as a
camcorder, video game console, any analog audio or optical digital
audio sources and composite video sources.
•
If your source has two output jacks indicative of stereo output,
insert both jacks into the T 758’s corresponding Front “L” (item A) and
“R (MONO)” input to achieve stereo output as well.
•
On the other hand, if your source has a single audio out jack only or
is marked “Mono output”, plug this into the T 758’s Front “R (MONO)”
input (item B).
•
Connect composite video output source to the front composite
video input (item C).
•
Use the front optical audio input (item D) for optical digital audio
sources.
12 FRONT MP/MIC INPUT
•
Connect your Media Player’s standard stereo phone jack to this
input.
•
This is also the same input where the supplied Audyssey
microphone is connected for Audyssey Setup calibration.
•
Refer also to the item about AUDYSSEY SETUP under the USING THE
T 758 - SETUP MENU segment of the OPERATION section.
IDENTIFICATION OF CONTROLS
FRONT PANEL
7
ENGLISH
POR
TUGUÊS
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ