16 of 53
GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
www.NabcoEntrances.com
P/N C-00106
Rev 8-10-16
2. Slide the door onto the Bracket portion of the Double Roller Assembly.
3. Breakout the Slide door to Full Open position.
a.
Support the weight of the Slide door.
4. Line up Bracket screw holes to the (2) pre-drilled screw holes located on Bottom Rail.
5. Secure Bracket to the Bottom Rail with (2) #10-31 x .50 Phillips Head screws.
6 .4 Install the Bottom Guide Assembly
(Full Open)
FOR FIXED SIDELITE UNITS SKIP TO
SUBSECTION 6.5
1. Go to Bottom Rail of the Slide door.
2. Locate the Bottom Guide Assembly that was preinstalled inside the Strike Stile.
3. Lift up the Prongs until the Bottom Guide is directly above the Guide Channels.
4. Allow the Prongs to drop down into the Guide Channels.
5. Obtain screws and anchors per NOA Documentation.
a.
NABCO does not supply screws and anchors to secure the Floor Track.
b. The number of screws and anchors depends upon length of Floor Track.
6. Permanently secure the Floor Track with scews and anchors.
Figure 27 Drop Prongs into Channel Guides
DN 0894
Li Up
Bo om Guide; Prongs
Guide Channels
6 .5 Adjust Rollers on Carrier
Do Not rotate the Roller Axle counter-clockwise. Doing so will unthread the Axle from the
Roller assembly.
1. To loosen a Roller, insert a 7/32” Allen wrench into the exposed end of a Roller Axle.
2. Hold the 7/32” Allen wrench in place to keep the Roller Axle stationary. At the same time, loosen (1) 7/16-20 Whizlock nut
with a 15/16” Open End Wrench.
DN 0897
Hanger Roller
An -Rise Roller
Eccentric Retainer Roller
End of Roller Axle
7/16-20 Whizlock Nut
Axle
Figure 28 Loosen Carrier Rollers
6 .6 Hanger Rollers
Hanger Rollers are used to:
►
►
Evenly distribute weight of the Slide door.
►
►
Adjust height of the Slide door.
►
►
Adjust the Leading edge of the Slide door at the top and bottom so it is parallel to another Slide Door (Bi-Part), or
the Strike Jamb Tube (Single), and the Header.
1. Loosen (2) Hanger Rollers located between the Anti-Rise Roller and the Eccentric Carrier Roller.
2. Raise or lower the Slide door by turning the Axle clockwise with a 15/16” Open End Wrench.
a.
The appropriate gap between the Bottom Rail and floor is between 11/16 inch to 15/16 inch; with the nominal gap
being 7/8 inch.
CAUTION