3 of 32
www.NabcoEntrances.com
SwingandFoldDoorOpusControlWiringandProgrammingInstallationManual
Rev. 8-11-21
P/N C-00139
CHAPTER 1: SAFETY
SECTION 1.1: Warning Labels
Warning labels are universal and used to alert an individual of potential harm to one’s self or to others. The following warning labels
are listed in a hierarchy order that defines the most potential danger first, and the least potential danger last.
Indicates potentially dangerous situations. Danger is used when there is a hazardous situation
where there is a
high
probability of severe injury or death. It should not be considered for
property damage unless personal injury risk is present.
Indicates a hazardous situation which has
some
probability of severe injury. It should not be
considered for property damage unless personal injury risk is present.
Indicates a hazardous situation which
may result in a minor injury
. Caution should not be
used when there is a possibility of serious injury. Caution should not be considered for
property damage accidents unless a personal injury risk is present.
Attention: A situation where material could be damaged or the function impaired.
Notice:
Indicates a statement of company policy as the message relates to the personal safety or protection of
property. Notice should not be used when there is a hazardous situation or personal risk
.
Note: Indicates important information that provides further instruction.
SECTION 1.2: General Safety Recommendations
Disconnect all power to the junction box prior to making any electrical connections. Failure to
do so may result in serious personal or fatal injury. When uncertain whether power supply is
disconnected, always verify using a voltmeter.
Do not place finger or uninsulated tools inside the electrical controller. Touching wires or
other parts inside the enclosure may cause electrical shock, serious injury or death.
Read, study and understand the installation and operating instructions contained in or
referenced in this manual before operating. If you do not understand the instruction, ask a
qualified technician. Failure to do so may result in
bodily injury or property damage and will
nullify all warranties.
The Ground wire from the Opus Control 120 VAC Harness, and the Incoming 120 VAC Ground
wire must be connected to the Ground screw located within the Swing door Header.
All electrical troubleshooting or service must be performed by trained, qualified electrical
technicians and comply with all applicable governing agency codes.
Do Not touch other parts of the Opus Control board with a screwdriver or anything else metal.
Damage to electrical circuitry may occur.
If the door appears broken or does not seem to work correctly, it should be immediately
removed from service until repairs can be carried out or a qualified service technician is
contacted for corrective action.
Notice: This manual, the owner’s manual and all other associated manuals must be given to and retained
by the purchasing facility or end user.
Notice: Wiring must meet all local, state, federal or other governing agency codes.
DANGER
WARNING
CAUTION
DANGER
DANGER
WARNING
CAUTION
CAUTION
CAUTION
CAUTION
