Model 710 Swing Door System
NABCO
ENTRANCES INC
877-622-2694
www.nabcoentrances.com
- 19 -
The installer first has to configure each of the doors independently with the
speeds and timing desired. Then adjust the potentiometers on the door controller
to closely mimic those settings.
Control Switches
An ON-OFF-HOLD OPEN switch assembly has been provided in the harness. It
can be mounted inside the header or where it is easily accessible to the customer.
D
rill a 7/8” diameter hole in the center of the location to install the switch. Use
the switch as a template to drill (2) 11/64” diameter mounting holes. Use the two
screws provided to mount the switch. It the switch assembly is not desired,
replace it with jumper from the parts bag.
Signage
After the door has been adjusted properly and tested, decals should be applied to
the door such that they are visible from either side of the door. Depending on the
type of the door activation, certain decals must be displayed. Refer to Section 6
of ANSI A156.19 Standard for Power Assist and Lower Energy Power Operated
Doors. Decals have been provided with the GT 710 to comply with all the
installation applications described in ANSI A156.19.
Simultaneous Pair
Installations
