33
FIGURE - 6.2
Ring Volume
Tuning
Door Open Button
Stairs Automation
Security
Doorkeeper
Handset
FIGURE - 6.1
DC24V
±
1 (from central unit)
0.5W (Min.), 8W (Max)
6 Wires
Full duplex
2 doorbell melody , 2 phone melody and 1 Alarm melody
ABS
Calling time : 30 sec, Talking Time : 60 sec
220 (Heigth) x 80,5 (Width) x 42,5 (depth) mm
-20°C - +40°C
IP20
TECHNICAL CHARACTERISTICS
Operation voltage
Power consumption
Connection
Audio communication
Calling Melody
Material Content
Monitor operating time
Dimensions
Operating temperature
Protection class
Functions
Call with the panel
Call with the security/ doorkeeper
Door Automation Control
Stairs Automation Control
Handset:
Allows audio output and input with speaker and microphone
Door Open Button
:
It is used to open entrance door.
Stairs Automation :
It is used to light up stairs.
Security :
It is used to call security. When the handset is hooked and button is pressed,
security phone is called. When the security accept the call, communication starts. If
either side does not end the phone call, after 60 seconds system automatically ends
the call. If there is more than one security on the system, in order to call first security
press button, to call second security press the switch of the handset once and press
button. If the same process is repeated, other securities are called.
Doorkeeper :
It is used to call doorkeeper in NVM series. When the handset is hooked
then button is pressed, doorkeeper phone is called. If there is more than one doorkeeper
in the system, in order to call first doorkeeper press the button, to call second doorkeeper
press the button again and then other securities will be called
Ring volume tuning:
Allows you to adjust ring volume tone.
PHONE FUNCTIONS
A - ID switch 1
B - ID switch 2
C - System connection socket
ID settings:
ID settings can be implemented by two ID grops for ND-105-7/ND-106-7 series. Diagram-
6.3.A shows the main ID group and diagram-6.3.B shows the slave phone ID group.
Second ID alwasy set to “1” if only one phone used in one flat.
Example: ID settings for 3 flats;
1st Phone :
1. ID = 1, 2. ID = 1
2nd Phone :
1. ID = 2, 2. ID = 1
3rd Phone :
1. ID = 3, 2. ID = 1
Example: ID settings for 3 flats with 1 slave phone for last phone:
1st Phone :
1. ID = 1, 2. ID = 1
2nd Phone :
1. ID = 2, 2. ID = 1
3rd Phone :
1. ID = 3, 2. ID = 1
3rd Phone :
1. ID = 3, 2. ID = 2
Be careful to make sure all IDs are set regarding to table-6.1 and 6.2 before the system is energised.
Be careful that all IDs are set unique and diffrent from “0”.
FIGURE - 6.3
A
B
C
ND-105-7/ND-106-7
DOORPHONE/DOORKEEPER UNIT (WITHOUT VIDEO)
Summary of Contents for GK-04-8
Page 2: ......
Page 50: ...45 FARKLI BA LANTI UYGULAMALARI BÖLÜM 10 ...
Page 68: ......
Page 116: ...45 DIFFERENT WIRING COMBINATIONS SECTION 10 ...
