14
Fig. 32
Fig. 33
Fig. 34
Remove the protective film from the back
of the adhesive keyboard using the
special tab. (Fig. 32)
Pass the antenna and keypad cable
completely through, inside the helmet.
Apply the keyboard to the shell and press
down on its entire surface to make sure
that it sticks properly. (Fig. 33)
Note: Make sure you do not glue the
antenna and keypad cable underneath
the keypad support.
Note: In the event that the keyboard is not
positioned correctly, peel it off right
away with extreme care and repeat the
positioning.
Note: It takes up to 24 hours for the
keyboard to stick completely. During
this time, do not expose the helmet to
atmospheric agents.
Hook up the “flex” cable of the adhesive
keyboard to the e-box. (Fig. 34)
Reposition the left polystyrene cheek pad
in its housing.
Only for full-face helmets: Insert the chin strap into the polystyrene cheek pad loop.
Reposition the left and right-hand side cheek pad by following the specific instructions
provided in the helmet user manual.
Hook the rear part of the comfort padding to the helmet.
Only for full-face helmets: Insert the chin guard (microphone side), gently placing the
microphone in its housing. Then press down on the red tab until the chin guard is
locked in place on the helmet.
