BX4 PLUS
15
Fig. 35
Only for flip-up / jet helmets:
Secure the neck roll (left side), being careful to
slide the neck roll plastic ring behind the
microphone, then clicking it in the press stud.
(Fig. 35)
Secure the neck roll (right side) by hooking up the
plastic ring to the press-stud.
Warning: Always verify the proper length of your chinstrap and adjust it if necessary,
referring to the specific helmet instructions.
Warning: After the
BX4 PLUS
is installed on the helmet, make sure the microphone is
properly positioned in front of your mouth, if necessary adjusting the moveable element.
Warning: The wind protector, supplied as standard equipment with helmets that can be
opened, may make it more difficult to open and close the chin guard when the
microphone is installed.
4.
REMOVING THE SYSTEM
To remove the system from the helmet, proceed as for the installation, by removing the
various parts. Important: to remove the keypad support, proceed as follows.
Fig. 36
Remove the keypad support from the
helmet shell (Fig. 36);
Take out the antenna from the plastic
support of the keypad (Fig. 37);
Remove the Flex cable of the keypad
from the connector found on the
electronic card;
Now completely remove the keypad
support from the helmet;
Bring the antenna inside the helmet,
passing it through the hole in the helmet
shell. (Fig. 38).
The keypad support can be removed in case you decide to no longer use the system.
However, it cannot be reused again as it will have lost its adhesive properties. Contact your
local dealer to purchase a new keypad support that will stick properly to the helmet shell.
Fig. 37
Fig. 38
