BX4 PLUS
9
Remove both comfort cheek pads, left and right, from the helmet (see specific
instructions in the helmet user manual). (Fig. 4)
Open the visor.
Remove the rear section of the comfort padding, pulling on the neck roll until it is
released from the shell (see specific instructions in the helmet user manual).Reposition
the padding on the outside of the helmet for the time being. (Fig. 5)
Remove the chin guard by pulling on the special red tab (Fig. 6a), then remove the
plug from the chin guard. (Fig. 6b)
Gently remove the polystyrene cheek pads by pulling them upward. (Fig. 7)
Warning: In case the polystyrene cheek pad is damaged during this operation, please
contact your local dealer to replace it.
In case the helmet is equipped with noise reducers on the comfort padding, lift them
up.
Take the comfort padding, left-hand and right-hand side and, if equipped, cut the pre-
drilled tab as shown in fig. 9 and fig. 10.
Fig. 8
Only for X701 – X603 - X602 helmets:
Take the polystyrene cheek pads that
have just been removed and, using a
pair of scissors, remove the round insert
by cutting the fabric securing points.
(Fig. 8)
Keep the foam used to cover the
speakers housing in case you wish to
use the helmet without the Bluetooth Kit
system.
Fig. 9 helmets X702GT - X701 – X603
Fig. 10 helmets X702