13
Position the slot of the neck roll, left side in the special housing on the Basic Kit2
(fig. 14).
Rotate the helmet looking at the N-Com housing in the shell (fig. 15) from the
outside.
While holding the Basic Kit2 and still looking at the N-Com housing on the shell,
insert the positioning tab in the groove A on the shell (fig. 16).
Align the 15-way connector with the shell and fasten it , making sure the
fastening clasp clicks.
Check the positioning of the Basic Kit2, left side, matching up the press-stud
with the hole in the Basic Kit2.
Put the left cheek pad back in its original position, making sure the press-stud
clicks. Now the Basic Kit2 is fixed to the inside of the shell.
Note: To facilitate the repositioning of the cheek pad, position the rear tab between
the Basic Kit2 and the polystyrene, push it in all the way and then align the press-
stud with the one on the shell (fig. 17).
Fig. 18
Fig. 19