14
By moving to another function with the menu key, the system automatically disconnects
the A2DP device.
Note: The Bluetooth intercom does not work while listening to an A2DP audio source.
11.
AUDIO DEVICES WITH CABLE CONNECTION
The range of N-Com products offers various “Multimedia Wire” accessories for connection
to external audio devices: MP3 players, i-Pods, Satellite navigators, GMRS and PMR radio
and audio systems pre-fitted on motorcycles (MCS).
To find out about all the available cables, please visit the website www.n-com.it in the
“Cable connection compatibility” section.
Note: Connect the 3.5-mm 4-pole connector of the Multimedia wire to the helmet and the
other end to the audio device. A coloured band on the cable indicates the connector to
be hooked up to the audio device
Once it is turned on, cable connection stays active even in the subsequent menus.
Consequently, you can hear the device connected via cable even while listening to music
via A2DP or via RADIO.
12.
RIDER-PASSENGER INTERCOM MODE
In order to use B4 in wireless intercom mode, both helmets have to be equipped with a
Bluetooth kit.
In order for two Bluetooth Kits to communicate with one another, they have to be paired
up first.
12.1.
Intercom affiliation
1.
Make sure both N-Com Bluetooth systems are turned off;
2.
Set both N-Com Bluetooth systems in Pairing up mode by pressing “on” (for more than
4 seconds), until the LEDS start to flash quickly;
3.
On either one of the two helmets, press “on” briefly;
4.
After a few seconds, the helmets “recognize” each another, a beep is emitted to signal
the pair up was successful and intercom communication is activated;
5.
Turn off both N-Com Bluetooth systems and turn them back on to store the pair up
data.
12.2.
Intercom function
After carrying out the proper pair up procedure, turn on the two helmets. Intercom
connection will be established automatically (this will take a few seconds. Wait until you
hear the acoustic signal confirming the operation).
If automatic connection is not possible, proceed with the manual connection.
Manual intercom activation
With B4 turned on, briefly press “on”.
Manual intercom deactivation
With B4 turned on, briefly press “on”.
