B4
11
5.
N-COM WIZARD
“N-Com Wizard” is the PC application that can be used to manage and
configure the B4 system.
The programme can be downloaded from the Internet site www.n-com.it, in the
“Download” section. In order to use it, a helmet equipped with B4 must be connected to
the PC, using the USB cable supplied with the system.
N-Com Wizard allows you to customize your B4, specifically:
Setting the system audio levels
Pre-set and manage your favourite radio stations
Update the device firmware
Turn on or off the Bike-to-Bike menu
Manage connections with other bikes
The programme includes an on-line guide that explains how it works (after installing it on
your PC, press F1 to display this guide).
6.
PAIRING UP BLUETOOTH DEVICES
In order for the B4 system to be connected to another Bluetooth device, the latter needs
to be first paired up with the N-Com system.
The pairing up procedure is the same for all Bluetooth devices: mobile phones, MP3
Bluetooth players, satellite navigators, etc.
1.
Make sure the B4 is turned off;
2.
Press “on” and keep it pressed (for more than 4 seconds), until the LEDs start to
flash quickly and you hear a sharp beep in the headset, indicating the “Pair-up
mode”;
3.
On the Bluetooth device, turn on the search for Bluetooth devices (refer to the
instructions manual of your device for the proper pairing up procedure, as it
varies depending on the brand and model of the device);
4.
After a few seconds, the mobile phone will display the name “N-Com Bt4 v.X.XX”,
followed by the manufacturer’s identification data;
5.
Select the N-Com device. If a password is requested, enter 0000 (four zeros);
6.
B4 will confirm the pairing up by means of a tone in the headset, and the LEDs
will stop flashing;
7.
Turn off and on both the mobile phone and the B4 to store the pairing up data.
Note: The affiliation is stored in the helmet and in the cell phone and it is not lost when
the two devices are turned off. As a result it needs to be carried out only once.
Note: If a Bluetooth device (mobile phone or GPS) equipped with music player with
Bluetooth A2DP player has already been paired up, the pairing up DOES NOT have to
be repeated as the A2DP protocol has already been stored in the B4.
Once the Bluetooth device has been paired up, connection is automatic when the system is
turned on.
In case connection is not automatically initiated after a few seconds, you can connect from
the Bluetooth device or by pressing “on” for 4 seconds.
