04
HI-LINE Super RC
5.0 Preparation
Before proceeding with the installation, unpack the carton
contents and check against the checklist below:
1.
HI-LINE Super RC fan convector.
2.
22mm isolating valves (1 pair).
3.
Instruction manual.
4.
Warranty card.
5.
Fixing kit (rubber mounts and cable gland).
6.
Remote control handset.
6.0 Fixing
l
Using the fixing dimensions below (see fig. 1), mark the fixing
hole positions on the wall.
l
Drill and plug the wall for No. 8 x 40mm round head wood
screws ensuring that the wall plugs are suitable for the wall
type.
l
Remove the backing from the self-adhesive washers and place
on screws with adhesive side towards the point.
l
Tighten the screws into the wall leaving about 9mm
projecting.
l
Press adhesive washers to the wall.
Remove the outer casing as follows:
l
Remove the screw securing each side panel (see fig. 2).
l
Remove 2 screws at each side securing outer cover.
l
Lift off the outer case.
l
Fit chassis on to mounting screws and tighten.
Note:
Before proceeding with pipe-work connections check that
the unit is level.
When water connections and electrical connections have been
completed and the unit has been vented, fit the outer cover and
secure with fixing screws.
Unit
A
Dimensions (mm)
29-20
1360
25-18
1150
Fig. 1
Fig. 2 Case fixing screw positions
Ceiling
150 min
each
side
A
53
103
63
275
77
144
92
a) 20 min
b) 100 min
a = rear entry pipework
b = top entry pipework
23674 HiLine Super RC manual 27/06/2011 09:25 Page 5
