38
Recalling test results and averages
4. Quick searching: If you want to see all values automatically displayed in sequence, first enter
the memory mode. Then
the right or left button for 2 seconds.
Anytime you want to
just release the button.
press
The right hand button is
for scrolling the most recent to oldest results; the left hand button scrolls from the oldest to the
most recent.
stop,
The current value will be
displayed. Any particular reading can thus be checked.
5. Reading immediately after test: If you have just finished a test, press the main button to enter
the "mem" (memory) mode and review this latest test result.
NOTE
Your control solution
will be automatically
but
be
recalled.
CS symbol
memory
.
test results
non-averaged,
may still
They will appear under the "
"
in the
mode
3. Non-averaging set and canceled:
You may select the unwanted or doubtful test
exclude them from the average
calculation, after
After
your
you can exclude an unwanted
the
button pressed and press the main button simultaneously to confirm the value as
"non-average".
. This value
flagged by the
If you want to cancel this
setting, stay in the test mode .
the
button until the "NO AVG" symbol changes to "AVG" in the upper
corner of the
screen. To confirm this original status you again simultaneously press the main
. The
value will
stored as a regular value and included in the average values.
results and
each test. After measurement, as long as the test strip is clicked in the meter it
is called "test mode". After removing the test strip it is called "memory mode".
finishing
test in the "test mode",
result by pressing the right hand
button until you see the symbol "NO AVG" in the top right hand corner of the screen. Keep
right hand
After removing the test strip from the meter the measured test result will be
stored in memory mode and cannot be amended
will now remain
"NO AVG" symbol.
non-average
"
" Press
right hand
right hand
button
now be
Recalling test results and averages
NOTE
- The average function is related to the time setting. Time and date must be set correctly to
PRECAUTION
-
-
results, control solution results and test results
out of normal
temperature range (
are not
in the
Time and date must be set in order to activate the average function.
"Lo" and "Hi"
recorded
<10
℃
and >40°C resp. <50°F and >104°F).
included
averages calculations.
39
enable averages to show. For example, the 14-day average will show no figure if there
have been no tests recorded in the 14 days prior to, and including, the current date.
"
"
have a result
memory mode ("mem"), this action cannot be performed.
- The non-averaging/re-averaging function only works in the test mode and when you
. In the
Summary of Contents for PURA X
Page 1: ......
Page 27: ...Distribution UK ...
