System Reset Switch (J5)
The J5 connector interfaces the system reset switch on the front panel of
the case. The switch causes the system board to perform a cold start
from the power-on self test without turning off power to components,
such as the hard disk drive.
J5-
Description
1 = Ground
2 = System Reset
Turbo Switch (J6)
The J6 connector interfaces the system board to a hardware turbo switch
on the front panel of the system unit. The turbo switch toggles the turbo
(high speed) mode on or off. The turbo function is disabled when the
hardware switch is not connected (default)
J6-
Description
Open
Low speed
Short
High speed (default)
Turbo LED (J7)
The J7 connects to an LED on the front panel of the system case to
indicate the state of the turbo mode. The LED will turn on whenever the
system is running in the turbo (high-speed) mode.
Manual No. 771924-D03, Mar. 1995
2-9
System Board Setup
