Mylex FlashPoint BT-930, Installation Manual And User'S Manual

Page: 57 / 70

Manual No. 3000863 Q&A-3
Q. I am connecting a removable drive to the Mylex
adapter in DOS. What device drivers do I need to
load?
A. In DOS, you need to load DOS Manager drivers in CONFIG.SYS as
follows:
device=c:\path\flashpt.sys /d
device=c:\path\btmdisk.sys
After that run BTFDISK program to create the partition on the drive
connected to second card and use the DOS FORMAT command to format
the drive.
Q. I am connecting a SCSI tape drive to the Mylex
adapter. What device driver do I need to load?
A. You need to load DOS Manager driver in CONFIG.SYS as follows:
device=c:\path\flashpt.sys /d
You also need tape backup software.
Q. I have a large capacity (more than 1GB) drive.
When I run FDISK, it recognizes only 1 GB capacity.
What is the problem?
A. Make sure you enable the DOS > 1 GB switch on the adapter. If you plan
to run NetWare, leave this option off and create your DOS partition in the
first 1G.
Q. I have a floppy tape backup and it runs very slowly
with the Mylex SCSI adapter. What should I do?
A. When you load DOS manager, use the “/n04” switch to reduce bus on
time from default 11us to 4us.