MYLAPS BibTag Timing system V.30. ENG. November 2020
© MYLAPS rights reserved 24
6.
Removal and Storage
Retrieve race data (if not already done):
•
Refer to Retrieve data (10.) to see how to retrieve data (race results) from the decoder
•
If no data connection to a Toolkit system is immediately available, data can be retrieved later (the decoder retains all
data in memory even when power is off).
Switch off power
•
•
Cho
n
•
will also power down the system
Disconnect cables
•
Remove antenna cables from their connectors on case
•
Remove power cable (if connected)
•
Remove Ethernet cable (if connected)
•
Remove starter pistol cable from I/O port (if connected)
Close case and move equipment
•
Carefully close lid (making sure that nothing
is trapped between cover)
•
Close both front latches
•
Move the BibTag equipment to a storage
area or to an area where race data can be
retrieved .
Store case in a dry area at storage temp of 0 °C to +40 °C (+32 °F to +104 °F), and close to a mains power socket
Charge Bibtag Decoder
•
Attach 100 - 240 VAC power cable into AC
connector on case
•
Connect the power cable into the mains
power socket
•
Leave power connected until BibTag is next
required (the battery will be automatically
charged so it stays fully charged)
Disassemble antennas
•
Carefully remove antennas from their slots in the antenna mats
•
Loop the cables and load them into their carry bags
•
Load all other cable accessories into their carry bags
Disassemble mats
Carefully lift the mats one-by-one so that they separate from the adjacent mat
Store mats
