MyBinding CubeX Trio, Instruction Manual

Page: 29 / 29

PRINT JET 3 Y OFFSET Compare the lines on “Y scale 1” and “Y scale 3” to find the ones that most
accurately line up . because variation is small, it may be easiest to spot 3
that look like they all line up . If this is the case, use the middle one as the
correct one .
Mark this line with a pen for easier identification.
On “Y scale 3” count from the center line (with the arrow) to the marked line .
If you are counting down, the scale the number is negative . If you are
counting up, the scale the number is positive .
Write down the offset .
In the example shown in figure 1, the Y offset for extruder 3 is +0 .6mm .
PRInT JeT 2 X OffseT Compare the lines on “X scale 1” and “X scale 2” to find the ones that most
accurately line up . because variation is small, it may be easiest to spot 3
that look like they all line up . If this is the case, use the middle one as the
correct one .
Mark this line with a pen for easier identification.
On “X scale “2 count from the center line (with the arrow) to the marked line .
If you are counting left, the scale the number is negative . If you are counting
right, the scale the number is positive .
Write down the offset .
In the example shown in figure 1, the X offset for extruder 2 is +0 .9mm .
PRINT JET 3 X OFFSET Compare the lines on “X scale 1” and “X scale 3” to find the ones that most
accurately line up . because variation is small, it may be easiest to spot 3
that look like they all line up . If this is the case, use the middle one as the
correct one .
Mark this line with a pen for easier identification.
On “X scale 3” count from the center line (with the arrow) to the marked line .
If you are counting left, the scale the number is negative . If you are counting
right, the scale the number is positive .
Write down the offset .
In the example shown in figure 1, the X offset for extruder 3 is +1 .1mm .
When you have finished inputting your offsets press the function button, the
printer will ask you if you wish to save your settings, use the tick and cross
to select yes or no .
27