11/09
CMT 130 Book Trimmer
2-4
In-Feed/Exit Options
Figure 2-7. In-Feed Bracket
3. Move the trimmer next to the elevator
such that the slots in the elevator
mounting brackets (Figure 2-8) line up
with the holes on the left side of the
trimmer's sheet metal enclosure.
4. Adjust the trimmer's leveling pads such
that the top of the table is 36" (914mm)
off the floor.
Figure 2-8. Elevator Mounting
5. Open the trimmer's front door and use a
level on the table inside the machine.
Level the front end of the machine by
adjusting the leveling pads. Keep the
final table height at 36".
6. Open the rear doors and repeat step 4
on the rear end of the machine.
7. Check the front end of the machine with
the level to make sure the front is still
level. Adjust as necessary.
8. Lock all (4) leveling pads in place by
tightening the jam nuts against the in-
side of the machine's base as in Figure
2-9. The nuts are accessed from inside
the machine.
Figure 2-9. Tighten Jam Nuts
9. Fasten the elevator mounting brackets
to the left side of the trimmer, Figure
2-8.
10. Connect shop air to the port at the rear
of the trimmer. Refer to 2.6 on page 2-
9.
At this point, the setup should similar to
Figure 2-10.
Figure 2-10. Current Progress