My Geko Gear Orbit 960, Quick User Manual

Page: 10 / 24

8
6. Screen Dormant: Off/ 1min/ 3min
To set the screen saver time, the dash cam’s LCD screen will turn off when it
goes without a handle period.
7. Key Tone: Off/On
Turn On/ Off Key Button Sound
8. Volume: Off/60%/80%100%
To control the noise level of the key button sound.
9. Language: EN/ZH
10. Time Setup: DD/MM/YY
Set the date and time. Press Up/Down button to properly set your date, press
OK to save your settings and then exit.
11. OSD: Date Stamp, LOGO Stamp, GPS Location stamp, Speed Stamp.
Date, time, LOGO, GPS location and speed will be stamped at the right bottom
corner of videos if it is enabled.
12. Driving Safety:
A: Driver Fatigue Alarm--off/ 1 hour/ 2 hours/4 hours: This setting is to alert and
remind the driver to take a rest from driving to promote safe driving habits.
B: Light Reminder—Off /On: The dash cam will make an alert sound to remind
the driver to turn their headlights on.
13. Record Mode: 1PFS/ Motion Detection/ Parking/ OFF
A: 1FPS
B: Motion Detection--If any movement is detected by the lens, the dash cam
will automatically start recording, and will stop recording when there is no
movement detected.
C: Parking Monitor – This function is triggered by the G-sensor embedded in
the dash cam. When parking mode is turned OFF, the G-sensor and CPU will
not work. When parking mode is turned ON, the dash cam will switch to
Parking Mode when the car is turned off.
14. Wi-Fi: OFF/ ON
Open Wi-Fi function
15. Format SD Card
： OK/ Cancel
Format the Memory Card
16. Format Warning: OFF, 15 days, 30 days, 60 days
To set the days to format the SD card, the dash cam will wipe the SD card data
at the set time.