MY
FireplaceBlower
NOTE: Diagrams and Illustrations NOT to Scale
Page 4 of 4
Installations in Canada must conform to the current CAN/CGAB-419.1 and .2 Gas Installation Code and local regula
-
tions. When installing the blower fan kit, it must be electrically grounded in accordance with CSA C22.1 Canadian
Electrical Code Part 1 and/or Local Codes.
Installations in the USA must conform to local codes, or in absence of local codes or the National Fuel Gas Code,
ANSI Z223.1-1988. When installing the blower fan kit, it must be grounded in accordance with local codes, or in
absence of local codes, with the National Electrical Code, ANSI/NFPA 70-1987.
My Fireplace Blower LLC produces and sells aftermarket fireplace blower kits; which require consultation
of an Owner’s Installation Manual from the Manufacturer of a particular fireplace model number for in
-
stallation. During Installation of a fireplace blower kit or replacement blower, refer to the Owner’s Instal
-
lation Manual for your particular fireplace model to obtain supplemental information. My Fireplace Blower
LLC is not responsible for any damage incurred during installation or resulting from installation of a fire
-
place blower kit, which was directed and/or conducted from the information within this document.
Figure: 7
Installer is responsible to check local codes
and read all instructions prior to installation.
Layout designed in U.S.A. © 2022
My Fireplace Blower LLC
Burlington, Wisconsin
1-800-466-4045
MyFireplaceBlower.com
Figure: 6
Step 6:
•Reinstall Upper and Lower Louvers; If gas supply
and/or 120 Volt Power are Turned Off, turn them
back on.
•Plug fan kit into 120-Volt grounded power supply
and test operation. (Figure: 10)
•The ON(AUTO)/OFF Rocker Switch controls
power to the blower (Figure: 7). The Blower will
not come on and shut off immediately with the
Heat Sensor installed.
Valve Cover
Shield
Switch
Bracket
Screw
3 Prong Plug
Grounded Outlet
ON
OF
F
ON (Auto) / OFF Switch
SMALL DIAL
The fan will not run until the Thermodisc / Heat Sensor reaches approximately 120°F
and the Variable Speed Control is turn to the “ON” Position! This means the Heat
Sensor must be in contact with a hot spot on the underside of the Firebox.
•To adjust minimum speed:
Rotate clockwise to decrease
low-end speed; counter-
clockwise to increase low-end
speed. (Figure: 8)
•Turn the dial to counter-
clockwise to increase
speed until it clicks off,
turn right to reduce
speed. (Figure: 9)
Figure: 8
Figure: 9
Figure: 10
