50˚ max
30
Subject to modifications
•
19, rue de Rennes
•
BP 83221 • F - 35690 ACIGNÉ
Check the tightness of the bracket after 10 and 50 hours work, then every 100 hours or at each engine draining
of the tractor. Contact your dealer if there is any loosening.
IMPORTANT:
Any fasteners/screws needing to be retightened must be inspected, replaced if necessary, cleaned and reassembled
using thread locking compound.
Tighten fasteners/screws in accordance with the tightening torque recommended in the table below.
(Fasteners/screws used on the tractor must not be tightened using an air gun.)
Tightening torques (Nm)
19. RECOMMENDATIONS FOR USE
—
Each implement has been designed for a specific use and has its own resistance limits.
—
Land clearing and stump pulling are prohibited. This work must be done with specialized machinery and is not
appropriate for the agricultural loader.
—
Use the tractor’s driving power to penetrate into the material to be moved rather than speed, which subjects the loader
and tractor to high stresses.
—
When the load to be moved is too big, do not force on the hydraulic components. The same applies when the rams
are fully extended. Release the control valve levers.
—
For ground levelling, work at slow speed with
an implement-to-ground angle of 50° at most.
Work flexibly and carefully.
Classe de visserie
Class of bolt
Schraubenart
Filetage -
Thread
-
Gewinde
M 5
M 6
M 8
M 10
M 12
M 14
M 16
M 18
M 20
M 22
M 24
M 27
8.8
5.2
9
21.6
43
73
117
180
259
363
495
625
915
10.9
7.6
13.2
31.8
63
108
172
264
369
517
704
890
1304
12.9
8.9
15.4
37.2
73
126
201
309
432
605
824
1041
1526