background image

1.

General Safety Rules

READ INSTRUCTIONS CAREFULLY. READ AND FOLLOW ALL INSTRUCTIONS. PLACE 

INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE. DO NOT ALLOW ANYONE 

WHO HAS NOT READ THESE INSTRUCTIONS TO ASSEMBLE, LIGHT, ADJUST OR 

OPERATE THE HEATER. 

IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE OR 

EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS 

OF LIFE.   

SERVICE MUST BE PERFORMED BY A QUALIFIED SERVICE AGENCY. 

UNVENTED PORTABLE HEATERS USE AIR (OXYGEN) FROM THE AREA IN WHICH IT IS 

USED. ADEQUATE COMBUSTION AND VENTILATION AIR MUST BE PROVIDED. REFER TO 

INSTRUCTIONS. 

WARNING 

DO NOT STORE OR USE GASOLINE OR  OTHER FLAMMABLE VAPORS AND LIQUIDS IN 

THE VICINITY OF THIS OR ANY OTHER APPLIANCE. 

WARNING 

FIRE, BURN, INHALATION, AND EXPLOSION HAZARD. KEEP SOLID COMBUSTIBLES, SUCH 

AS BUILDING MATERIALS, PAPER OR CARDBOARD, A SAFE DISTANCE AWAY FROM THE 

HEATER AS RECOMMENDED BY THE INSTRUCTIONS. NEVER USE THE HEATER IN 

SPACES WHICH DO OR MAY CONTAIN VOLATILE OR AIRBORNE COMBUSTIBLES, OR 

PRODUCTS SUCH AS GASOLINE, SOLVENTS, PAINT THINNER, DUST PARTICLES OR 

UNKNOWN CHEMICALS. 

WARNING 

DIRECT-FIRED HEATERS MAY CAUSE CARBON MONOXIDE (CO) POISONING WHEN 

INCORRECTLY USED, E.G INDOORS WITHOUT ADEQUATE AIR CIRCULATION, OR IF NOT 

PROPERLY WORKING. CO POISONING MAY LEAD TO DEATH. 

GENERAL HAZARD WARNING 

FAILURE TO COMPLY WITH THE PRECAUTIONS AND INSTRUCTIONS PROVIDED WITH 

THIS HEATER, CAN RESULT IN DEATH, SERIOUS BODILY INJURY AND PROPERTY LOSS 

OR DAMAGE FROM HAZARDS OF FIRE, EXPLOSION, BURN, ASPHYXIATION, CARBON 

MONOXIDE POISONING, AND/OR ELECTRICAL SHOCK. ONLY PERSONS WHO CAN 

UNDERSTAND AND FOLLOW THE INSTRUCTIONS SHOULD USE OR SERVICE THIS 

HEATER. IF YOU NEED ASSISTANCE OR HEATER INFORMATION SUCH AS AN 

INSTRUCTIONS MANUAL, LABELS, ETC. CONTACT THE MANUFACTURER. 

WARNING 

NOT FOR HOME OR RECREATIONAL VEHICLE USE 

WARNING 

YOUR SAFETY IS IMPORTANT TO YOU AND TO OTHERS, 

SO PLEASE READ THESE INSTRUCTIONS BEFORE YOU OPERATE THIS HEATER 

THE ELECTRICAL SYSTEM TO WHICH THE APPLIANCE IS CONNECTED MUST COMPLY 

WITH CURRENT LEGISLATION. INSTALLATION REQUIRES A RESIDUAL CURRENT 

CIRCUIT BREAKER (RCCB) IN THE MAIN ELECTRICAL DISTRIBUTION BOARD.   
UNPLUG THE APPLIANCE BEFORE PERFORMING ANY MAINTENANCE OPERATIONS. 
ALWAYS CHECK THE POWER CABLE BEFORE USING THE APPLIANCE. IT MUST NOT 

BE BENT, TAUT, STRETCHED, CRUSHED OR ANY WAY DAMAGED. 
THE POWER CABLE MUST BE REPLACED BY QUALIFIED PERSONNEL ONLY. USE AN 

ORIGINAL POWER CABLE ONLY WITH A 3-PIN APPROVED PLUG.   
THE FRONT OUTLET IS VERY HOT DURING OPERATION. DO NOT TOUCH! BURN 

DANGER.

 

M1.0.WD340.EN

Summary of Contents for BGO-100A-16-F











Reviews: