10
M1.3.PROTECT670.NLFREN 12062018
EN
Safety instructions
• Read and understand all instructions before use.
• The welding helm is designed to protect the eyes and face from sparks, spatter and harmful radiation under normal welding
conditions. It will not protect against severe impact hazards, including fragmenting grinding disks.
• This helmet will never protect against explosive devices or corrosive liquids. Machine guards or eye splash protection must
be used when these hazards are present.
•
Impact resistant, primary eye protection, spectacles or goggles that meet appropriate protection specifications, must be
worn at all times when using this welding helmet.
•
Avoid work positions that could expose unprotected areas of the body to sparks, spatter, direct and/or reflected radiations.
Use adequate protection if exposure can not be avoided.
• The welding helmet applies to all kinds of welding operations.
•
The auto darkening filter must be equipped with outside protection plate to prevent potential unrepairable hazard.
•
Change the scratched or broken lens frame that reduces visual field and protection as soon as possible.
• Change the scratched or broken protection plate, do not bump into lens during replacement.
• The operating temperature range is -5 °C to +55 °C. When ambient temperature is below the lower limit, the response
speed of liquid crystal materials of lens frame assembly will be a little slower, no other protection will be affected.
• Do not store lens frame in a location near a heat source or in a high moisture place.
• Do not clean lens frame with alcohol, gasoline, or diluted solvents, and do not immerse it into water.
• Frequently change the sweatband.
• Change failure parts with the parts provided by the authorised supplier.
• Should this helmet not darken upon striking an arc, stop welding immediately and contact your supervisor or your dealer.
Before welding
•
Check front cover lens to make sure that they are clean, and that no dirt is covering the sensors on the front of filter
cartridge. Also check the front/inside cover lens and the front lens retaining frame to make sure that they are secured.
• Inspect all operating parts before each use for signs of damage. Any scratched, cracked, or pitted parts should be replaced
immediately before using again to avoid severe personal injury.
• Check for light tightness before each use.
• Select the shade number you require at the turn of a shade knob. Finally be sure that the shade number is the correct
setting for your application.
• Adjust headband so that the helmet is seated as low as possible on the head and close to your face. Adjust helmet’s angle
when in lowered position by turning the adjustable angle limitation washer.
•
Do not make any modifications to either the welding lens or helmet, other than those specified in this manual. Unauthorised
modifications and replacement parts will void the warranty and expose the user to the risk of personal injury.
•
Failure to follow these warnings and/or failure to follow all of the operating instructions could result in severe personal
injury.
Product features
•
This product is of completely new design, with shell material high and low temperature resistant, corrosion resistant, flame
retardant, soft, light tight, intensity high, and durable.
•
Clear vision on the workpiece both prior and during welding, which means improved quality and higher efficiency.
• Overall process protection against ultraviolet (UV) and infrared (IR) radiation.
• The helmet is equipped with lithium battery and solar cells that extends the life of the battery.
•
The product is in full conformity with related ANSI, CE, CSA, AS, NZS safety standard.
copyrighted
document
- all
rights
reserved
by
FBC
