MVP D3 SERIES, Product Instructions, Page: 9 / 19

6
Input Power Configuration for 24 VAC/ VDC
110 – 220 VAC Power Source
Single Phase Only
Step Down Transformer
High Voltage to 24 VAC
For 24 VAC/VDC inputs;
Installer must take a moment to allow input configuration for Low Voltage Input.
Use Blue 24 VAC Bypass Cable To hook up Power inside D3 as shown below.
Site Power Available
Inside all D3-MVP is a Chassis similar to shown
Locate Green Plug on Chassis
All Wiring Connections are
to be made fully inside of D3
Then insert similar Plug
on 24V Bypass Cable
Tighten screws on plug to secure
Locate 24V Bypass Cable in
Hardware Pack Provided
24 VDC: Connect wires to appropriate Color
coded terminal shown above.
24 VAC: hook-up has no polarity
24 VDC Color Code:
Red = + Positive
Blue = - Negative
When all wiring is complete, secure screws from plug to panel mount,
Then secure all wiring to be sure it does not interfere/ damage fan(s)
or camera pan - tilt operation
Unplug Green Plug on Chassis
from panel mount socket, then
push aside
The MVP comes ready for 110-220VAC Input power
Run 24V into D3 via weatherproof wiring ports provided.
Connect wires to appropriate Color Coded terminal shown here