MV Tec Compac, Manual

Page: 19 / 23

19
Automatic dispensing of espresso
The keys A B C D are used for automatic dispensing of espresso.
Automatic dispensing means that the operator presses one of the four keys to begin the supply.
When the programmed quantity of coffee in the cup is reached, the machine stops “automatically” the
dispensing.
Semi-automatic dispensing of espresso
Key E has to be used for semi-automatic dispensing of espresso (and for the programming of the different remaining ; see
related section).
Press key “E” to begin the supply and press again to stop the supply.
Dispensing Hot Water
The hot water is dispensed from the hot water wand (fig. 1.3) by turning the hot water handle.
Caution: The wand becomes extremely hot during hot water dispensing and can cause burns. Do not touch!!
Steam dispensing
The hot steam is dispensed from the steam wand (fig. 1.2) by turning the steam handle (fig. 1.1)
Caution: The wand becomes extremely hot during steaming and can cause burns. Do not touch!!
To avoid milk rests to dry on the wand, we strongly recommend to clean the wand with a humid non abrasive cloth after
every use. Pay attention during this operation: the wand becomes extremely hot during steaming and can cause burns.
Setting of coffee and hot water portions
Programming is done on standby machine ready to operate.
Programming begins pressing the key E on the touch pad on left side of the machine from operator side.
a. Press key E on the touch pad for more than 5 seconds.
b. Release key E and press the key to be programmed (A B C D F ). The led on the key lights on
and erogation begins.
c. When the wished quantity is reached (coffee or hot water) press the lighted key and the erogation
stops.