MV Tec Compac, Manual

Page: 16 / 23

16
4. Installation
The espresso machine Compac is to be installed to comply with the applicable federal, state or local plumbing codes having
jurisdiction.
The manufacturer has tried to foresee all possible safety devices to ensure the safety of the users.
Anyhow different conditions of installation or of equipment moving can cause situations which cannot
be controlled or foreseen. Therefore it’s absolutely necessary to evaluate all remaining risks and to
care about the following:
◆
Installation and maintenance must be carried out by technicians and service providers authorized by the manufacturer.
◆
The appliance is only to be installed in locations where use and maintenance is restricted to trained personnel.
◆
Any defect or discrepancy has to be notified immediately to the authorized persons for installation and maintenance.
◆
A residual current device (RCD) having a rated residual operating current not exceeding 30mA must be installed.
◆
This machine is safe only when it has been correctly connected to an efficient grounding/earthing system, implemented
in accordance with the current safety regulations.
◆
All electrical connections have to be effected exclusively by authorized and qualified technicians. Any improper cable
connection is forbidden.
◆
Check the integrity of all components and do not install defective or damaged parts. Ask for replacement.
◆
Check that capacity of the electrical system is sufficient for the maximum rated power shown on the data rating plate of
the machine.
◆
The customer has to protect the electrical feeding of the machine by means of a safety switch system of 30 mA.
◆
The machine must be installed with an electrical switch with adequate fuses and safety devices.
◆
The machines with electrical input over 16 A, must be connected to a net with impedance = or < than 0,37 Ω.
◆
The machine has to operate with clean soft drinking water. Building up of scale will seriously damage this equipment and
can also cause injuries. If necessary, install a inlet filter.
◆
Before installation, the manufacturer strongly recommends to control the water supply system and the electrical
connections.
◆
Check the efficiency of the machine’s main drain. Then proceed with the connection of the water drain hose to the
machine. Check again pouring an adequate quantity of water directly into machine’s drain tray (located under the drip
tray).
◆
This equipment must be installed on a fl at, level and stable surface. The minimum height of this surface is 1025 mm.
◆
Handle the machine with care.
◆
Do not leave such packing items as plastic bags, styrofoam, nails, etc. around because children or other people could get
hurt or damaged.
◆
In case of substitution of the water inlet hose, the used one is not to be reused.