MV Agusta 2008 F4 312RR 1078, Workshop Manual

Page: 84 / 124

- 22 -
Crankcase
D
Reassembling water pump parts
During the following procedure use the nec-
essary precautions so as not to get burned
A)Position pump casing ( 1 ) on the special tool to allow
the insertion of the shaft and then heat it to 120°C.
B)Fit the oil seal on the engine side ( 8 ). Always fit new
rings after carefully degreasing them with alcohol.
C)Fit the first bearing ( 7 ).
D)Fit the tip on shaft ( 5 ) and then insert the shaft into
its housing.
E)Fit the second bearing ( 6 ).
F) Lock the assembly in place by fitting Seeger ring ( 3 ).
Rotate the pump 180 degrees.
G) Fit the second outer oil seal ( 9 ).
H)Screw the tip off the shaft.
I) Turn in impeller (
4 ).
L) Insert the two seeger rings ( 2 )
M)Insert the two pump body tightening screws ( 1 ) and
unite the latter to its cap.
8
7
5
6
9
4