MV Agusta 2008 F4 312RR 1078, Workshop Manual

Page: 105 / 124

- 5 -
E
Lubrication
Substitute oil filter
Take an oil filter out of (black version) the new motor oil
filter kit (Part code n° 8000A3702) of new furnishing.
Exclusively us MV Agusta components.
Take the new motor oil filter gasket out of the oil filter
kit (Part code N° 8000A3702) and fit it on the filter as
shown in the figure.
WARNING: Be sure to use a new seal.
Slide the seal until it comes into contact with the rear
oil filter ring (see figure).
Before fitting the filter, lubricate the seal.
Fit the filter into its seat. Manually rotate the filter until
the seal lightly touches the worked surface.
Tighten the filter using the appropriate tool, code
99010 and a dynamometric key
Tightening couple: 24 N·m .
Once the filter has been tightened, Take the new motor
oil filter clamp and the relative screw out of the oil filter
kit of new furnishing. (Part. Cod. N° 8000A3702).
WARNING: Be sure to use a new clamp.
Fit the clamp and slide it until it touches the rear oil fil-
ter ring.
Place the clamp fastener 1 mm from the screw on the
crankcase.
Turn the clamp screw until the clamp comes into con-
tact with the oil filter. Make sure there is no clearance
between the clamp-seal assembly and the filter.
Mark the screwing point on the screw as well as on the
clamp with a marker.
Carry out the final tightening of the screws by making
2 turns and 1/2 beyond the already obtained position
(see fig.).
1 mm