© MuxLab Inc.
Active VGA Managed Repeater Hub Installation Guide
Page 13
3.5. Installation
Procedure
In order to install the product, please follow the steps
below:
1.
Place the Active VGA Managed Repeater Hub in its
final location.
2.
Connect the Dispatcher to the Repeater Hub by
using a UTP/STP Cat 5e/6 cable. This cable
connects from the Dispatcher’s front panel to the
LINK (Local In) port located on the Repeater Hub’s
back panel.
3.
Optional: Connect a local display to the Repeater
Hub via the VGA (Local Out) port located on the
Repeater Hub’s back panel.
4.
Connect the Repeater Hub to Receivers using
UTP/STP Cat 5e/6 cables. These cables connect
from the Link Ports located on the Repeater Hub’s
front panel to the LINK IN port located on the back
panel of each Receiver.
5.
Power up the Dispatcher, Receivers, and local
displays.
6.
Connect the external 12VDC power supply to the
Repeater Hub and plug the power supply into an AC
power outlet. If power is available, the power LED
will be ON.
7.
Ensure that the source and appropriate displays are
on. Images should appear on the displays. Check the
image quality and refer to the troubleshooting table
in Section 4 if image quality is unsatisfactory.
