© MuxLab Inc .
Passive CCTV Power Integrator Hub Installation
Guide
Page 15
6.
If remote power is being transmitted to the camera,
verify that the distance between the camera and the
hub is within MuxLab specifications. Please consult
the distance charts at the back of the installation
guide. When the port switch is set to Pass-Thru
Mode (500022), two (2) twisted pairs are used for
remote power. When the port switch is set to
Power-Thru Mode (500024/500029), three (3)
twisted pairs are used for remote power thus
supporting greater distance.
7.
In order to transmit video on one (1) twisted pair,
remote power on two (2) twisted pairs and control
on one (1) twisted pair, set the port switch to Pass-
Thru Mode (500022) using a small flathead
screwdriver, as shown in fig 6. Ensure that there is a
CCTV Pass-Thru Balun (500022) at the camera.
Figure 6: Port Setting – Pass-Thru Mode (500022)
8.
In order to transmit video on one (1) twisted pair and
remote power on three (3) twisted pairs, set the port
switch to Power-Thru Mode (500024/500029) using
a small flathead screwdriver (fig 7). Ensure that there
is a CCTV Power-Thru Balun (500024 or 500029) at
the camera.
