Operation Instructions ValueJet 1604W
Chapter 4 : Periodical maintenance
50
AP-77300 – Rev 1.1 -17/09/2009,
4.1.5 Head cleaning
Be sure to read and understand the safety warnings before handling the printer.
When to perform?
Perform a head clean if the prints become blurred or are incomplete.
Notes
Remove media while cleaning.
Step 1 :
Verify that the operation panel is in Normal mode.
Step 2 :
Verify that the media hold lever is lowered
Step 3 :
Press the [>] key to select the cleaning mode.
Step 4 :
Press the [Cleaning] key for at least 2 seconds.
The operation panel displays “Cleaning **%”.
After performing the head cleaning operation, the operation panel shifts to Normal.
Notes
Pressing the [Cleaning] key again after the 1st head cleaning performs a strong cleaning. If you fail to
remove blurs or incompleteness of printing in one head cleaning, perform a strong cleaning.
If you fail to remove blurs or incompleteness of printing with several head cleaning, refer to
Troubleshooting
, and perform the adequate process.
