Operation Instructions ValueJet 1604W
Chapter 3 : Installing the Unit
27
AP-77300 – Rev 1.1 -17/09/2009,
3.1.2 Switching the power OFF
Be sure to read and understand the safety warnings before handling the printer.
Step 1 :
Before powering OFF, be sure that:
Printing or other operations are stopped or finished.
The printer (and operation panel) is in normal mode.
The low lamp on the operation panel lights green.
Notes
If the High lamp on the operation panel lights up green, the head height is set to high. Return the head
height to low before powering OFF.
Step 2 :
Press the [Power] key to switch OFF the printer.
The Power indicating light on the operation panel switches OFF.
Notes
If the [POWER] key is pressed or the power indication light lights up green, the power is ON.
Press the key once again and switch OFF the power.
The printer starts the power OFF procedure.
The operation panel displays “Power OFF.
Notes
If the head height is set to high it displays “Change Head Gap Low”. The procedure to power OFF
stops. To restart the procedure, return the head height to low.
All the indication lights on the operation panel and the LCD monitor are switched OFF.
The printer automatically switches the power OFF.
Notes
If there is a problem during the Power OFF sequence, the printer displays a message on the operation
panel and may stop operating.
In the case operation stops, refer to
“Troubleshooting”
.
After switching OFF the printer, wait for 10 seconds or longer to switch it ON again.
Step 3 :
Raise the media hold lever after the powering OFF cycle, so you will not damage the media by
the pressure of the grid rollers.
