Wire Routing Continued
12.
Disconnect rubber boot from both ends. Reach inside door frame and fish out the
Signal
® mirror wires.
13.
Using a fish wire, guide the
Signal
® mirror wires through rubber boot.
Note: Route the Signal® mirror wires in-between the two connectors
as shown.
Reconnect the OE connectors and route the
Signal
® mirror wires into vehicle. Reseat rubber boot into place.
14.
Repeat steps for the passenger side
Signal
® mirror. Route passenger side
Signal
® mirror wires to driver side kick panel area. Using a utility knife,
separate the red and black wires from both
Signal
® mirror wire harnesses. Label the red wire of each
Signal
® mirror wire harness accordingly
(DRIVER SIDE and PASSENGER SIDE). Trim the black wires from both harnesses to length. Strip and twist the black wires together and crimp
them to the supplied grounding ring terminal. Pull on the black wires and the grounding ring terminal to make sure the connection is secure.
Attach the grounding ring terminal to the grounding bolt near the kick panel area.
12
Signal® Mirror wires
13
14
Grounding bolt (source)
4
Summary of Contents for signal mirror
Page 10: ...5...
