7
4) Your device is ready to be repacked (see Repacking p. 9).
Usage Below Freezing
When the temperature is below freezing, the Inflatable PfD should
be worn partially inflated because a fully discharged cylinder may
not quickly or adequately inflate your Inflatable PfD. Under these
conditions use the oral inflator to adequately top-up the PfD, after
CO
2
inflation.
WARNING: CO
2
inflation could over-pressurize and damage your
Inflatable PFD if already fully inflated.
Re-arming Your PFD (MD3071)
NOTE: A re-arm kit (MA7203) is required for this procedure.
IMPORTANT: Follow instructions in the exact sequence below.
1) Open bottom cover flap so that manual inflator is exposed (fig. 7).
2) Remove the cylinder/bayonet assembly by rotating
counterclockwise and then pull out.
Discard the used cylinder/
bayonet assembly.
3) Check the new cylinder/bayonet assembly to ensure the o-ring is
in place and the sensor ring is attached (fig. 7). Ensure that the
CO
2
cylinder has not been pierced (fig. 7).
Dust cap
position for
deflation
Dust cap
in stowed
position
Oral Inflator
FIGURE 6
Cap In
Deflate
Position
FIGURE 5
Summary of Contents for MD3071
Page 22: ......
