As from: 02.05.2006
Murrplastik Systemtechnik - ACS Werner Tubach
28
8902864602
MP Engraving unit
3.0 Assembly and connection
3.8 Installing the spindle in the engraving head
(By default the engraving head will be delivered with the spindle already installed – this
chapter only refers to the case if the spindle has to be installed after a change of spindle or
engraving needle)
Place the spindle in the engraving head up to the mechanical
stop and make sure the red marker on the depth regulator is
pointing to the Zero mark on the white ring.
Then screw tightly the spindle.
By default an engraving tool is
already inserted in the spindle:
0.5 mm cutting diameter
15° top angle
