Murex Tradestig 150, Instruction Manual And Spare Parts List

Page: 7 / 40

- 7 -
bt35d1ea
5 INSTALLATION
The installation must be executed by a professional.
Note!
Mains supply requirements
High power equipment may, due to the primary current drawn from the mains supply, influence the
power quality of the grid. Therefore connection restrictions or requirements regarding the
maximum permissible mains impedance or the required minimum supply capacity at the interface
point to the public grid may apply for some types of equipment (see technical data). In this case it
is the responsibility of the installer or user of the equipment to ensure, by consultation with the
distrubution network operator if necessary, that the equipment may be connected.
5.1 Location
Position the welding power source such that its cooling air inlets and outlets are not
obstructed.
5.2 Mains power supply
Check that the welding power source is connected to the correct mains power supply
voltage, and that it is protected by the correct fuse size.
A protective earth connection must be made in
accordance with regulations.
Rating plate with supply connection data
Recommended fuse sizes and minimum cable area
Tradestig 150 Tradestig 220
TIG MMA TIG MMA
Mains voltage 230 V 10 %,
1
230 V 10 %,
1
230 V 10 %,
1
230 V 10 %,
1
Mains frequency 50/60 Hz 50/60 Hz 50/60 Hz 50/60 Hz
Mains cable area mm
2
3G2.5 3G2.5 3G2.5 3G2.5
Phase current I
1eff
9 A 11 A 11 A 14 A
Fuse
anti-surge
type C MCB 16 A
13 A
16 A
13 A
16 A
16 A
16 A
16 A
NOTE! The mains cable areas and fuse sizes as shown above are in accordance with Swedish
regulations. Use the welding power source in accordance with the relevant national regulations.
GB