NOTE: BEFORE PERFORMING STEP 9 REFER TO ELECTRICAL INSTALLATION ON PAGE 6.
6. Completely flush water supply lines of all foreign debris, before connecting to the fixture.
INSTALLATION: (see drainage & mounting roughing-in pg. 2 or 3)
8. Install removable access panel using #10-32 x 1/2” provided.
9. Test for leaks and proper operation, and then install the door using the hinges provided.
2. Carefully remove all fixture components from packaging, preventing scratching or damage.
6. Attach hinged door assembly to mounting frame by latching insert clip hinges. Make necessary adjustments to
hinges with the adjustment screw to prevent door from rubbing on wall when opening. Refer to door hinge
adjustment detail below.
4. Make up the 3/8” O.D. Copper inlet supply connection to chiller and Bottle Filler.
3. Provide mounting surface, sufficient to support the fixture and loads on the fixture.
PRIOR TO INSTALLATION
:
1. Read all installation instructions carefully, before proceeding.
4. Provide rough-ins as shown on the roughing-in and dimensional drawing, including water supply, drain pipe
and gravel drain well. (See pages 2 or 3 for rough-in details)
2. Using #10-32 x 1/2” Hex Btn Screws provided mount bottle filler mounting frame to the MF10 frame assembly.
3. Place the Chiller Unit onto the basepan of the MF10 Frame Assembly.
7. Make up all power connections to the ground, neutral & hot within the electrical box and chiller unit.
1. Insert MF10 Frame assembly into the rough-in block out and secure using 1/4”-20 UNC mounting hardware
(Provided by others)
5. On the semi-recessed bottler filler assembly, unlock and swing open the hinged door assembly to expose
internal components. Disconnect 1/4” O.D. polyethylene tube connection from the hinged door assembly. Then
remove the hinged door assembly from mounting frame by unlatching insert clip hinges.
5. Loosen slip nuts to orientate P-trap to desired direction then tighten slip nuts and make up 1-1/4” O.D. waste
connection.
ANGLE ADJUSTMENT
HORIZONTAL ADJUSTMENT
HINGE ADJUSTMENT
Horizontal
Adjustment
Screw
Phillips Head
Screwdriver
Door Hinge
Horizontal
Adjustment
Screw
Angle
Adjustment
Screw
Phillips Head
Screwdriver
Door Hinge
Angle
Adjustment
Screw
MURDOCK MFG. •
15125 Proctor Avenue • City of Industry, CA 91746 USA
Phone 800-453-7465 or 626-333-2543 • Fax 626-855-4860 • www.murdockmfg.com
Member of
7013-037-001
Revised: 07/26/18
Page 4 of 16
I N S TA L L AT I O N / M A I N T E N A N C E I N S T R U C T I O N S
Semi-Recessed Bottle Fillers
