Configuring the Network
You can configure the HopNet network using a PC and the HopNet
Configuration Wizard software provided by Cirronet, Inc. The Wizard runs
under Windows 98/NT/2000/XP. This chapter provides the information you
need to configure your network.
HopNet Configuration Wizard (5.0 or later)
If you haven’t already installed the Wizard program, refer to the
Getting
Started
section of this manual for instructions. Open the Wizard by double-
clicking on the icon on the desktop. When the Wizard boots up, it will
automatically detect the serial port to which the HopNet radio is connected
and its baud rate. This process takes a few seconds to complete. During this
process, the “Please wait” screen is displayed. Once the radio has been
found and the Baudrate determined, the “Finished” screen is displayed. Click
on the Continue button to enter the Wizard.
NOTE: The HopNet configuration Wizard is used with a variety of
Cirronet radios. Not all radios support all the functions and features of
every Cirronet radio. Thus, some selections in the Wizard will be grayed
out if they are not applicable to the radio in use.
After detecting the serial port and baud rate of the HopNet radio, the Wizard
reads the settings of the HopNet radio that is connected to the PC and will
display them in the various parameter windows. In the bottom left corner of
the Wizard window, the Base/Remote status, the serial number and the
communication port are always displayed.
Copyright © Murata Manufacturing Co., Ltd. All Rights Reserved. 2012
HN-210D/X, HN-214D/X Rev. 2.0 01/13/17
17 of 64
www.murata.com
