23
© Munters Corporation, August 2021
QM1077r16
Step 27
Use a straight edge or level to check alignment
of Propeller Sheave, Tensioner Pulley and Motor
Sheave. If needed, adjust position of Motor Sheave
so the 3 pulleys line up. Once Motor Sheave is
aligned tighten the set screw to 75 in-lbs [9 N-m]
torque.
See Figure 27.
Installation Instructions
Chapter 2
Propeller Sheave
Figure 27
Tensioner Pulley
Motor Sheave
Level
Step 28A
Slide V-belt over Propeller and install by wrapping
it around 2 smaller pulleys and starting it over
larger Sheave. Continue rolling it onto the larger
Sheave until it fits into groove.
See Figure 28A.
Figure 28A
Step 26B
Using channel locks and/or a hammer twist the Motor Bracket Stiffener so that the holes in the bracket lay
flat against the framing. Then attach Stiffener to framing using (1) Lag Screw [LL].
See Figure 26B.
Figure 26B
Frame
Stiff ener
Lag Screw [LL]
