FORM: QM1070
Rev.3, February 2010
Page 7 of 15
Munters Corporation
4215 Legion Dr. Mason, MI 48854-1036 USA
(517) 676-7070 Fax (517) 676-7078
www.munters.us/aerotech
Eyelets at each joint
of Cone Sections
Figure 7B
Figure 7A
Cone
Fan
Guard
1
/
4
" Flange
Nut [C]
¼" x ¾" Wafer
Head Bolt [B]
Guard
Cone
Sections
Step 9
Push cone sections together at each joint to tighten cone
around guard. Tighten wafer head bolts and nuts at all
joints, taking care not to overtighten. Tighten all bolts
holding guard in place.
If fan was ordered with 'PR' style shutter proceed to
Step
10
. If the 'PV' style shutter was ordered then proceed to
Step 12.
Step 8
Remove Fasteners [B] and [C] in outer holes. Insert guard into cone with the guard eyelets facing away from you.
Make sure each eyelet lines up with a hole in the cone sections, and secure with the (4) Fasteners [B] and [C],
previously removed.
DO NOT
tighten bolts at this time.
See Figure 7A, 7B.
Step 7
Lift cone assembly up and slide onto outlet of fan and
fasten using (4) Fasteners [B] and [C].
See Figure 6.
Finger tighten only. Bolts must be installed from inside to
outside.
Cone Section
(Outside)
1
/
4
" Flange Nut [C]
Figure 6
¼" x ¾" Wafer Head Bolt [B]
Fan Outlet
(Inside)