5
4. Locate the sensor wire and boot inside the electrical outlet
assembly.
5. Connect the quick disconnect fittings, closest to the rubber
boot, to the pressure sensor. Cover this connection with the
boot by sliding it into place.
6. Connect the remaining quick disconnect fittings over the
spade terminals of the temperature sensor.
7. Attach the female end of the discharge hose assembly to the
90˚ elbow of the discharge assembly and the male end to the
irrigation inlet fitting.
8. Plug the electrical cord into the electrical outlet.
1. The pump control is prewired to the electrical outlet assembly.
2. To wire the pump control to your irrigation controller, refer to
the wiring diagram inside the control panel.
Wire motor for correct voltage. See
“Motor & Electrical” section of this
manual and motor nameplate.
Ground motor before connecting to
power supply.
Meet National Electrical Code,
Canadian Electrical Code, and local
codes for all wiring.
Follow wiring instructions in this
manual when connecting motor to
power.
Step 2 – Setting and finalizing the pump (Continued)
Step 3 – Wiring the pump control to the irrigation controller
Munro Complete PRO ll
ASSEMBLY GUIDE
