9
Step 5 – Changing the Pump Direction (Continued)
Pressure Gauge and Pressure Sensor
3. Use a wrench to remove the pressure gauge and sensor
assembly from back-side opening.
4. Relocate the gauge and pressure sensor assembly to the
opposite (now front facing) side of the pump, ending parallel
to pump motor.
Discharge Fittings
5. Reinstall the discharge assembly in the top discharge port.
6. In most cases, the open end of 90 elbow should be pointing to
the back of the pump.
Note: Pipe dope or Teflon tape is needed at each connection point. Fully tighten
each connection with a pipe wrench.
Final Appearance
7. The installation of pump fittings should be complete and
appear as pictured.
drainage assembly
Munro Complete PRO ll
ASSEMBLY GUIDE
