PAGE 11
OMNI-SYSTEM
CONFIGURATION MENU
SPREADER MAIN
SETTINGS:
Setting Retain: Use the liquid knob to toggle the
retain settings feature. This functionality allows the
controller to retain the Auger, Liquid, and Spinner
rates through power cycles.
CAUTION: This will cause the spreader controller
to retain the settings after the controller has been
powered off. Be aware that anytime the spreader
functionality on the controller is activated, the motors
will initiate at the last settings.
Manual Mode Enable: Manual mode can be toggled
on or off. Disabling manual mode will prevent the
operator from accessing this mode above 7 MPH.
Allowing operators to access under 7 MPH is
necessary to allow material to be offloaded.
0 SPN: The 0 MPH spinner feature allows the
spinner operation to halt when the truck comes
to a stop. If the setting is configured for “spinner
on” the spinner will remain spinning regardless
of truck speed.
Blast LVL: The blast level sets the auger speed
when the blast button is pressed. This is adjustable
from 0-100%. Use the liquid knob to change.
Blast Time: The blast duration can be adjusted from
0 – 255 seconds. Use the spinner knob to change.
Take-Off Timer: The take-off timer is only applicable
to Auto Mode, and it is intended to help expedite
material output as a vehicle accelerates from a
stop. This setting is adjustable from 0 - 20 seconds.
Turning this setting above 0 will cause the auger
to blast material. Use the spinner knob to adjust
this setting.
SPREADER MAIN
SETTING RETAIN
0 SPN
OFF
OFF
MAIN MODE
ENABLE
ON
BLAST
LVL
TIME
ENABLE
100%
005s
TAKE OFF
TIMER
00s