Multivets Anti-Bark Spray Collar Delux, Instruction Manual, Page: 2 / 32

2. Feed the free end of the collar into the slot of the buckle that is closest to the Multivet
logo, from the back to the front (A). Then, thread the free end of the collar through
the outside slot, from the front to the back (B). The free end should now hang on the
outside, then thread the keeper (C). When you have completed this section, the
assembled collar looks as shown (D).
Take off all other collars your dog may be wearing and place the
spray collar around his neck, making sure the spray valve is directed
toward the snout. Adjust the collar to fit like a regular collar. You
should be able to easily pass two fingers between your dog’s neck
and the device (A). We suggest that you check the collar regularly
to make sure that it is well adjusted.
Note: If these instructions are not properly followed, the buckle can easily be
pulled off the collar. This could lead to the device being lost or damaged.
Your dog must get used to the device before you actually start using it. We suggest
that you make your dog wear the Anti-Bark Spray Collar during 4 to 5 days before
inserting the battery and filling the device. At the same time, we also suggest that you
remove and put the collar back frequently on your dog.
Filling the device
The Anti-Bark Spray Collar Deluxe has a see-through reservoir with a level indicator to
help you see when your reservoir is getting empty (A).
1. Set the device on a flat surface with the fill-up valve (the deepest cavity) turned
upwards (B). Shake the spray can before using it.
2. Hold the can upside down, then insert the aerosol tip in the fill-up valve (C) – press
down firmly for 10 seconds (D). Release pressure and press down for another 10
seconds, then release.
Note: If spray is escaping as you attempt to fill the device, increase the downward
pressure on the refill can to get a better seal. When completely filled, there should
be enough gas in your device for 18-23 sprays.
A B C D
A
A B C D