VOIP Placement
MultiVOIP Quick Start Guide
12
Placement
Mount your MultiVOIP in a safe and convenient location
where cables for your network and phone system are
accessible. Detailed instructions for unpacking and
cabling the MVP130 are in
Chapter 3: Mechanical Installation
& Cabling
of the User Guide
.
Command/Control Computer Setup
(Specs & Settings)
The computer used for command and control of the
MultiVOIP
(a) must be an IBM-compatible PC,
(b) must use a Microsoft operating system,
(c) must have an available serial COM port.
The configuration tasks and control tasks the PC will have
to do with the MultiVOIP are not especially demanding.
Still, we recommend using a reasonably new computer.
The computer that you use to configure your MultiVOIP
need not be dedicated to the MultiVOIP after installation
is complete.
COM port on controller PC.
You’ll need an available
COM port on the controller PC. You’ll need to know
which COM port is available for use with the MultiVOIP
(COM1, COM2, etc.).
Summary of Contents for MultiVOIP MVP130-AV-FXS
