2
Installing the Cell Modem and SIM Card
To install the cell modem on the Field PC complete the following
instructions.
1.
Power off the handheld by holding down the power button
for a few seconds and select Power Off.
2.
Remove the rubber cover from the pack.
3.
Insert SIM card carefully making sure that the card is
inserted in the correct orientation. The beveled corner on
the card will line up with the outline on the socket with the
gold electrical contacts facing towards the connector.
CAUTION:
There is space between the case and the connector. When inserting the card make
sure that the card is inserted into the connector and not into the space above or below the
connector.
4.
Replace the rubber cover. Run a finger around the outside edge to make sure the gasket is
flush with the case. Note: The top portion of the gasket is not flush.
CAUTION:
If the rubber cover is not replaced the unit is no longer sealed and the warranty is
void.
5.
Remove the four screws from the back of the handheld.
Note: They do not have to be completely removed from
the back.
6.
Remove the back of the handheld.
7.
Slide the top of the handstrap up to detach it from the back.
8.
Place the pack on the back of the handheld.
9.
Tighten the four screws to attach the pack.
10.
Slide the handstrap onto the two screws to reattach it.
11.
Attach antenna to the cell modem. Use the knurled ring at
the bottom of the antenna to tighten the antenna. Do not
twist on the antenna rod to tighten the antenna.
12.
Turn on the unit.
Running the Cell Modem Setup Utility
If the CellModemSetup utility is not already installed on the handheld go to
http://update.carlsonsw.com/kbase_main.php?action=display_topic&topic_id=693
to download it.
To install the utility on the handheld, connect the handheld to a PC using ActiveSync then run
the cell modem setup install program on a desktop PC.
1.
To start the utility, tap
Start > Programs > CellModemSetup
.
2.
This screen will be displayed:
!
!
