Multitech MT5600DSVD2, User Manual

Page: 46 / 94

MultiModemDSVD User Guide
38
Command: \N n Error Correction Mode Selection
Values: n = 0–5
Default: 3
Description: \N0 Normal (non-error correction) mode with data buffering.
(Forces
&Q6
.)
\N1 Direct mode. Equivalent of &M0 and &Q0 modes. (Forces &Q0 .)
\N2 V.42/MNP reliable (error-correction) mode. The modem at-
tempts first a V.42 connection and then an MNP connection.
Failure to make a reliable connection results in the modem
hanging up. (Forces
&Q5 , S36=4 , and S48=7 .)
\N3 V.42/MNP auto-reliable mode. The modem attempts first to
connect in V.42 mode, then in MNP mode, and finally in non-
error-correction mode with data buffering. (Forces
&Q5 , S36=7 ,
and S48=7 .)
\N4 V.42 (LAPM) reliable mode.If the modem cannot make a V.42
connection, it disconnects. (Forces
&Q5 and S48=0 .) Note: The
-K1
command can override the
\N4
command.
\N5 MNP reliable mode.If the modem cannot make an MNP con-
nection, it disconnects. (Forces
&Q5 , S36=4 , and S48=128 .)
Command: \V n Single Line Connect Message
Values: n = 0 or 1
Default: 0
Description: \V0 Disables single line connect message. Connect messages are
controlled by the
X and W command settings.
\V1 Enables single line connect messages in the format: CONNECT
< Serial Port Speed ></ Modulation ></ Protocol ></ Compres-
sion ></ Line Speed >/< Voice and Data >. Connect messages are
displayed in the single line format subject to the commands V
and
Q
. In non-verbose mode (
V0
), single line connect messages
are disabled and a single numeric result code is generated for
CONNECT .
Command: +MS= Modulation Selection
Values: See description.
Default: See description.
Description: This extended-format command selects modulation and, op-
tionally, enables or disables automode, specifies the lowest and
highest connection rates, selects µ-Law or A-Law codec type,
and enables or disables robbed bit signaling detection using
one to five subparameters.
The command format is: +MS=< mod >[,[< automode >]
[,[< min_rate >][,[< max_rate >][,[< x_law >][,[< rb_signaling >]]]]]]<CR>
Subparameters that are not entered retain their current value.
Commas separate optional subparameters, and should be in-
serted to skip a subparameter. Example:
+MS=,0,<CR> dis-
ables automode and keeps all other settings at their current
values.
+MS? Reports current options in the format: +MS:
<
mod >,< automode >,< min_rate >,< max_rate >,< x_law >,< rb_signaling >
Example: +MS: 56,1,300,56000,0,0.