Multitech MT5600DSVD2, User Manual

Page: 38 / 94

MultiModemDSVD User Guide
30
Command: Q n Result Codes Enable/Disable
Values: n = 0 or 1
Default: 0
Description: Q0 Enable result codes.
Q1 Disable result codes.
Command: S r Select Register
Values: r = S-register number
Default: None
Description: Selects register S r as the last register accessed. E.g., S0 . The
command AT? can then be used to read the register, and the
command AT= n can then be used to set the register to value n .
Command: S r=n Set Register Value
Values: r = S-register number; n varies
Default: None
Description: Set value of register S r to n , where n is entered in decimal for-
mat. E.g., S0=1 . If the short form AT= n is used, the value is
written to the last accessed S-register.
Command: S r? Read Register Value
Values: r = S-register number
Default: None
Description: Read value of register S r and display it in 3-digit decimal for-
mat. E.g., S2? gives the response 043 . If the short form AT? is
used, the last accessed S-register is read.
Command: T Tone Dialing
Values: P, T
Default: T
Description: Configures the modem for DTMF (touch-tone) dialing. Dialed
digits are tone dialed until a
P command or dial modifier is
received.
Command: V n Result Code Format
Values: n = 0 or 1
Default: 1
Description: V0 Displays result codes as digits (terse response).
V1 Displays result codes as words (verbose response).
Command: W n Connect Message Control
Values: n = 0, 1, or 2
Default: 0
Description: W0 The CONNECT result code reports the serial port speed. Other
responses are disabled.
W1 The CONNECT result code reports the line speed, the error
correction protocol, and the serial port speed, respectively.
Other responses are disabled.
W2 The CONNECT result code reports the line speed only. Other
responses are disabled.
Note: See also the \V command