Multitech BA-Series, User Manual

Page: 92 / 109

92
MultiModemBA User Guide
Xn n = 0,1,2,3 or 4 * X0 selects Basic Result Codes (w/o CONNECT
1200, CONNECT 2400).
X1 selects Extended Result Codes (w/CONNECT
1200, CONNECT 2400).
X2 selects Standard AT Command set with NO
DIAL TONE.
X3 selects Standard AT Command set with BUSY.
X4 selects Standard AT Command set with NO
DIAL TONE and BUSY.
#Xn n= 0 or 1 * #X0 selects single XOFF character sent until XON
level returns.
#X1 selects multiple XOFF characters after buffer
level is full.
Yn n = 0 or 1 * Y0 disables sending or responding to long space
“break”.
Y1 enables sending or responding to long space
“breaks”.
Z
All configuration parameters are reset to default
values.
, In Dial Command Causes pause during dialing.
; In Dial Command Causes return to Command Mode after dialing.
! In Dial Command Causes modem to flash On-Hook.
@ In Dial Command Causes modem to wait for ringback, then 5 seconds
of silence before processing next part of command.
+++AT<CR> In-band Escape Sequence. Places modem in
Command Mode while still remaining On-Line. Enter
+++ followed by the letters A and T, up to ten
command characters, and a RETURN.
BREAK AT<CR> Out-of-band Escape Sequence. Places modem in
Command mode while still remaining On- Line.
Enter a BREAK signal, followed by the letters
A and
T, up to sixty command characters, and hit
RETURN.
* Factory Default Setting